suprema Alarm Zone How To Configure
suprema Alarm Zone How To Configure

suprema Alarm Zone How To Configure

Advertisement

2021/03/11 08:32
Table of Contents
...................................................................................................................................
- http://kb.supremainc.com/knowledge/
/
........................................................................................................
..........................................................................................................................
..........................................................................................................................
How to Configure an Alarm Zone
1
1
4
4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Alarm Zone and is the answer not in the manual?

Questions and answers

Summary of Contents for suprema Alarm Zone

  • Page 1 2021/03/11 08:32 How to Configure an Alarm Zone Table of Contents How to Configure an Alarm Zone ......................Configuration ........................... Video Demonstration .......................... Supported Devices .......................... - http://kb.supremainc.com/knowledge/...
  • Page 2 Note that only local zone with RS485 connection is supported right now. Global zone, which would be server matching of the zone information is currently unavailable. The alarm zone can detect intrusion based on the configured input and the sensor of the door is also used for detecting intrusion.
  • Page 3 You need a BioStar 2 AC Standard License to use the Zone menu. 5. Select Intrusion Alarm and click Apply. 6. Select a Name for your Alarm zone. Currently only Local Mode (RS-485 connection) is available with BioStar 2.5. 7. Select your Door that will sense the intrusion.
  • Page 4 2021/03/11 08:32 How to Configure an Alarm Zone Arm Delay Time: device will wait and make a beep sound for the number of seconds configured before arming. Disarm Delay Time: device will not make an alarm action on Intrusion alarm detected event for the configured number of seconds when intrusion is detected.
  • Page 5 The events shown in the image below are the events available for the Alarm zone. If you want to turn off the Alert Sound after an Alarm event you have to Clear Alarm in the Monitoring >...
  • Page 6 - P2 FW 1.0.0 - R2 FW 1.0.0 The devices below supports alarm zone from BioStar 2.6.0 - BioStation L2 FW 1.3.0 or above - W2 FW 1.2.0 or above - FaceStation 2 FW 1.1.0 or above Other entry devices do not support this zone.

Table of Contents