Table of Contents
Advertisement
6 Installation
6.2 Mounting Wall-mounting Bracket
To avoid electrical shock or other injury, please inspect existing electronic or plumbing installations before
drilling holes.
Danger
Procedure:
1) Use the wall-mounting bracket as a template and mark the positions of the drill holes, then drill the 4 holes
accordingly, as per FIG. 6-6. (Diameter = 11mm, Depth ≥ 55mm).
Note: The external dimensions (W × H) of inverter are shown as dash line in FIG. 6-6.
2) Drill expansion anchors into the corresponding four holes, and then secure the bracket by using screws, as per FIG.
6-7 & FIG. 6-8.
FIG.6-7 Install Expansion Anchors
6.3 Installing Inverter
Note: It must be ensured that the wall-mounting bracket was accurately mounted fixed to the wall before installing
the inverter.
Procedure:
1) Hang the inverter on wall-mounting bracket. Keep balance during the operation to prevent device damage from
colliding with walls or obstacles, as per FIG. 6-9.
2) Use two safety bolts to fix both sides of inverter to ensure the inverter fixed to the wall firmly, as per FIG. 6-10.
FIG. 6-9 Hang the Inverter on Wall-mounting Bracket
74.5
250
FIG.6-6 Drilling Positions (W x H, 399 x 446mm)
FIG.6-8 Fix Wall-mounting Bracket
FIG. 6-10 Fix Both Sides of Inverter
7 / 17
Advertisement
Table of Contents
