Table of Contents
Advertisement
Blade is twisting
Unusual wear on
side/back of blade
Teeth missing/ripped
from blade
Motor running too hot
No coolant flow
Excessive speed
reducer noise/
vibration
Replacement Parts
This section provides exploded view illustrations that show the replacement parts for the 10-inch x 16-inch Cut-
Off Saw. Also provided are parts listings that provide p art number and description. The item numbers shown on
the illustration relate to the item number in the facing parts listing.
Order replacement parts from:
JET
427 New Sanford Road
LaVergne, Tennessee 37086
Ph.: 800-274-6848
Identify the replacement part by the part number shown in the parts listing. Be sure to include the model
number and serial number of your machine when ordering replacement parts to assure that you will receive the
correct part.
1. Blade is binding in the cut.
2. Blade tension too high.
1. Blade guides worn
2. Blade guide bearings not adjusted.
3. Blade guide bearing bracket is
loose.
1. Blade tooth pitch too coarse for
workpiece.
2. Feed too slow; feed too fast.
3. Workpiece vibrating.
4. Gullets loading up with chips.
1. Blade tension too high.
2. Drive belt tension too high.
3. Blade too coarse for workpiece
(especially with tubular stock).
4. Blade too fine for workpiece
(especially with heavier, soft
material).
5. Speed reducer gears require
lubrication.
1. Pump motor is burned out.
2. Screen/filter on pump is clogged.
3. Impeller is loose.
4. Coolant level too low.
1. V-belt is too tight.
2. Countering spring not tensioned
properly.
1. Decrease feed pressure.
2. Decrease tension on blade
1. Replace blade guides.
2. Adjust blade guide bearings.
3. Tighten blade guide bearing
bracket.
1. Use blade with finer tooth pitch.
2. Increase feed pressure and/or
blade speed.
3. Clamp workpiece securely.
4a. Use blade with a coarse tooth
pitch—reduce feed pressure.
4b. Brush blade to remove chips.
1. Reduce tension on blade.
2. Reduce tension on drive belt.
3. Use blade with fine tooth pitch.
4. Use blade with coarse tooth pitch.
5. Check speed reducer.
1. Replace pump.
2. Clean screen/filter.
3. Tighten impeller.
4. Add coolant to reservoir.
1. Reset V-belt tension.
2. Increase spring tension.
21
Advertisement
Table of Contents
