Electrical - Jet J-7040M-4 Operating Instructions And Parts Manual

Electrical

Observe the following when connecting to the power source. (Refer to the wiring diagrams in Figures 23 - 26.)
WARNING: JET RECOMMENDS THAT ANY HARD WIRING OF THE SAW TO A BRANCH, OR ANY CHANGE
OF VOLTAGE SUPPLIED TO THE MOTOR BE PERFORMED BY A LICENSED ELECTRICIAN.
1. Make sure the saw is disconnected from the power source, or that the fuses have been removed or breakers
tripped in the circuit in which the saw will be connected. Make sure you put a warning placard on the fuse or
circuit breaker to prevent accidental electrical shock.
2. If you are installing the motor power cord into a receptacle, make sure to use the appropriate plug.
3. If you are using hard-wired connections to a junction box, connect the wires in the box, and close the box.
4. Install the fuses or reset the breaker .
5. The saw is now ready for service.
18
Figure 23: Model J-7020M cut-off saw wiring diagram