Table of Contents
Advertisement
E
THERNET PORT
This port can be used to receive remote commands defined in SCS (Software Communication Specification) or any other
•
10M/100M auto sensing network interface
•
Networking: Static or DHCP IPv4 addressing
•
Subnet Mask: Configurable. Default 255.255.255.0
•
Default Gateway: 0.0.0.0
•
UDP protocol. Port 9999
To configure Ethernet port, press
Following any changes to the Ethernet setting, power must be recycled for the change to take effect.
Figure 3
If DHCP is selected,
PROTEUS's IP address can be viewed by pressing
and select
"Edit: COM Port
Setting". Follow
F9
Figure 3 - Figure 5
Figure 4
Alt-h
(several times)
as shown in
Figure 6
9
CSV1 type data
to enable Ethernet port and select IP address.
Figure 5
Figure
6.
formats.
Advertisement
Table of Contents
