Com Ports : Configuration; Com1; Com2; Com3: Usb Device Port - VideoLogic Proteus-V User Manual

COM :
PORTS CONFIGURATION
Press F9 to display the Main Menu. Follow

COM1

COM1 (DB9) is configured as DTE (PC) i.e., RX=Pin2, TX=Pin3. Thus, sensors such as GPS can be directly connected to the DB9 without the need for NULL
modem cable. However, when using COM1, a
This port can be used to receive remote commands defined in SCS (Software Communication Specification) or connect any RS232 sensor/device that
transmits CSV1, CSV2, CSV3, CSV4, SSV3, SSV4

COM2

COM2 is located internal. Signals TX & RX are provided at J16 connector (Compatible with Garmin GPS 18x LVC) as well as
This port can also be used to receive remote commands defined in SCS (Software Communication Specification) or connect any RS232 sensor/device that
transmits CSV1, CSV2, CSV3, CSV4, SSV3, SSV4
COM3: USB
DEVICE PORT
When connected to a PC, it will enumerate as a COM port. This port can be used to receive remote commands defined in SCS (Software Communication
Specification) or CSV1 type formats. This port is also used to upgrade the internal firmware.
USB
HOST PORTS
PROTEUS has 2 USB host ports. Typical devices connected to these ports are USB keyboard and USB Flash drive for storing KML data.
to configure COM ports for desire baud rate & device.
Figure 1-Figure 2
Figure 1
NULL modem cable is required to interface PROTEUS to a PC.
type data formats.
type data formats.
7
Figure 2
Terminal Block J54.