Table of Contents
Advertisement
Free utility
can be used to send commands to Proteus. Follow
to configure Packet Sender only once.
Packet Sender
Figure 7
Figure 7
Follow
to send commands to Proteus. For example, use any text editor i.e.,
and open file "0-TestCommands.txt" located
Figure 8 - Figure 9
Notepad++
in the Script folder. Copy all commands as shown in
and paste it into the
Edit box shown in
and press Send. The result should
Figure 8
ASCII
Figure 9
appear on your video screen as shown in
Figure
10.
Each command must end with \n. If multiple commands are sent in one packet, end each command with
\n
as shown below:
\n
\n
\n"
"$VL43,46,777*XX
$VL43,51,Target777*XX
$VL04,75,7C0000FF*XX
There is no benefit updating parameters any faster than video frame rate i.e., screen refresh rate. For example, when using 1080p @30Hz which
is the fastest frame rate Proteus can handle, keep parameter update rate to 30Hz or less. Typical parameter refresh rate is 10Hz.
Avoid transmitting UDP packets back-to-back. If multiple commands need to be transmitted back-to-back, concatenate them into one payload
as shown above and transmit using one UDP packet.
Figure 9
Figure 8
Figure 10
10
Advertisement
Table of Contents
