Appendix B - Updating Firmware - VideoLogic Proteus-V User Manual

This section assumes you have already installed
1. Toggle CFG switch in the rear panel to the lower position
2. Cycle power to PROTEUS
3. Connect mini USB cable from your PC to PROTEUS
4. Your PC should acknowledge PROTEUS with a beep. Alternatively, Device Manager will add the following:
5. Start Renesas Flash Programmer. As shown below, ensure Current Project is GVO.rpj. If confirmed, go to step 6.
If not, go to File, Open Project and load it from the folder established in Appendix C i.e.
To avoid repeating this step in the future, go to File and Save Project.
A B – U
PPENDIX PDATING FIRMWARE
'Renesas Flash Programmer'
59
described in Appendix C.
C:\VideoLogix-V\Firmware.