Tripp Lite B127A-002-BH Owner's Manual page 20

Installation
1. Make sure all equipment in the installation—such as TVs,
Blu-ray players and the transmitter—is powered OFF.
2. Using an HDMI 2.0 cable (such as Tripp Lite P569-XXX-CERT
or P568-XXX-2A Series cables), connect the HDMI source to
the INPUT port on the local splitter unit.
3. Optional: For extended range, connect up to eight B127A-
010-H signal repeater units between splitter and each
receiver via Cat6 cabling.
4a. Optional for B127A-008-BH: Using an HDMI 2.0 cable
4. Using Cat6 cable (such as Tripp Lite N202-Series 24AWG
Cat6 Cabling), connect the RJ45 port on the local splitter unit
to the RJ45 port on the remote receiver unit.
5. Using an HDMI 2.0 cable (such as Tripp Lite P569-XXX-CERT
or P568-XXX-2A Series cables), connect the remote receiver
unit's HDMI port to a monitor.
-08-019-933DB9-EN.indd 20 -08-019-933DB9-EN.indd 20
(such as Tripp Lite P569-XXX-CERT or P568-XXX-2A Series
cables), connect a local monitor to the LOCALOUT port on
the B127A-008-BH local splitter unit. The LOCAL (orange)
LED will illuminate to indicate a display has been connected
to the local port.
or
4b. Optional for B127A-008-BH:
B127A-002-BH, B127A-004-BH or B127A-008-BH splitter
unit via the local HDMI port (sold separately). Repeat steps 4
and 5 below as necessary.
Note: The HDMI local display port only supports 4K/60Hz resolutions
and will not work properly with lesser resolutions.
Cascade an additional
20
8/24/2021 3:07:50 PM 8/24/2021 3:07:50 PM