Tripp Lite B127A-002-BH Owner's Manual page 16

Installation
3. Optional: For extended range, connect up to four
4a. Optional for B127A-004-BHPH3: Using an HDMI 2.0 cable
5. Using Cat6 cable (such as Tripp Lite N202-Series 24 AWG
6. Using an HDMI 2.0 cable (such as Tripp Lite P569-XXX-CERT
7. Turn on the power to your connected TVs/monitors. The
-08-019-933DB9-EN.indd 16 -08-019-933DB9-EN.indd 16
B127A-010-H signal repeater units between splitter and
each receiver via Cat6 cabling.
(such as Tripp Lite P569-XXX-CERT or P568-XXX-2A Series
cables), connect a local monitor to the LOCAL OUT port
on the B127A-004-BHPH3 local splitter unit. The LOCAL
(orange) LED will illuminate to indicate a display has been
connected to the local port.
Note: The HDMI local display port only supports 4K/60Hz resolutions
and will not work properly with lesser resolutions.
or
4b. Optional for B127A-004-BHPH3:
B127A-002-BH, B127A-004-BH or B127A-008-BH splitter
unit via the local HDMI port (sold separately). Repeat steps
4 and 5 below as necessary.
Cat6 Cabling), connect the RJ45 port on the local splitter
unit to the RJ45 port on the remote receiver unit.
or P568-XXX-2A Series cables), connect the remote receiver
unit's HDMI port to a monitor.
LOCAL (orange) LED will illuminate to indicate the local port
has been connected to a display.
Cascade an additional
16
8/24/2021 3:07:49 PM 8/24/2021 3:07:49 PM