EchoStar AD-3600 IP Viaccess User Manual page 13

F
IXED DISH INSTALLATION WITH
3. Install the F-connector (DiSEqC switch) to the LNB IN connector (receiver).
4. Install the delivered loop through cable between the IF OUT connector (receiver) to the
LNB IN ANALOG connector (receiver).
M
OTORIZED DISH INSTALLATION WITH
1. On the dish installation (for detailed instructions refer to the manufacturer's instructions):
a. connect a RF cable;
b. connect the power and sensor cables;
c. if present, set the East and West limit switches to prevent dish damage.
2. On the rear panel of the receiver find:
a. the LNB IN (digital), the IF OUT and the LNB IN ANALOG, connectors;
b. the M.PULSE, the GND, the M1 and the M2 connectors.
3. Install the F-connector (dish) to the LNB IN connector (receiver).
4. Install the delivered loop through cable between the IF OUT connector (receiver) to the
LNB IN ANALOG connector (receiver).
5. On the rear panel of the receiver find the M.PULSE, the GND, the M1 and M2 connectors.
6. First install the motor sensor cables to the M.PULSE and GND connector (receiver).
7. Install the motor power cable to the M1 and M2 connectors (receiver).
D
ISH INSTALLATION WITH
1. On the dish installation, connect the ferrite cables (for detailed instructions refer to the
manufacturer's instructions).
2. On the rear panel of the receiver find the Ferrite + and the Ferrite - connectors.
3. Install the ferrite power cable to the Ferrite + and Ferrite - connectors (receiver).
D
ISH INSTALLATION WITH
1. On the dish installation, connect the polarotor cables (for detailed instructions refer to the
manufacturer's instructions).
2. On the rear panel of the receiver find the + 5V, the GND and the SKEW connectors.
CAUTION
It is possible that the GND connector is already occupied by the motor sensor
cable. If you need to connect the GND for the polarotor as well, please use the
appropriate connection materials to connect both cables. Failing to do so can
cause damage to the equipment.
3. Install the polarotor power cable to the + 5V and GND connectors (receiver).
4. Install the polarotor skew cable to the SKEW connector (receiver).
Digital Satellite Receiver
D SE C
I Q SWITCH
LNB(F)
F
ERRITE FEED
P
OLAROTOR
Installation
Section 3
Page 3 - 3
3