Advanced Installation - EchoStar D-2510 IP Viaccess User Manual

C. Advanced Installation

Advanced Installation

You can select the "Advanced Installation" menu
on the "Installation" menu of Main menu by using
the Channel up/down keys (Ù,Ú).
Edit/Add SAT or TP
Edit/Add SAT or TP
Satellite
1
Longitude
2
3
TP / Signal Quality
4 LNB polarization
5
Symbol Rate
6
FEC
7
Channel Name
8
Video PID
9
Audio PID
10
PCR PID
i
To edit any satellite or transponder, select satellite and transponder to be edited.
You can change the name of the satellite, transponder, channel name and such.
To change channel name, place highlight bar to "8 Channel Name" and keep pressing
one of either the or the key till it reaches "??? Add ch".
Then, press the OK key to activate graphic key board and now you can edit the name up to 10-characters
in length. For some words,, maximum number of the characters is 11. And, mostly 8 characters from
the start shall be shown on the menu when you finish changing name.
Note 1) You should execute "Auto Search" after editing the satellite or the transponder.
If the "Auto Search" is executed after adding the new transponder, all channels of the added
transponder will be searched and stored automatically.
CAUTION: By doing an "Auto Channel" search you will lose all the data
Note 2) You can add or edit a total 50 satellites. This includes the pre-programmed satellites.
The receiver has the cap ability to store up to 999 transponders and 5000 channels.
×
ASTRA1
019.2 °E
0
Vertical
0
AUTO
????????
0
0
Auto
(e.g. FAV, Lock...) which you have edited.
Advanced Installation
i
Edit/Add SAT or TP
Ø
10
i
25
Edit/Add SAT or TP
1
2 Edit LNB Local Freq.
Auto Sat
3
4
Reset (Factory Default)
Satellite
1
Longitude
2
3
TP / Signal Quality
? ? ?
4 LNB polarization
5
Symbol Rate
6
FEC
7
Channel Name
8
Video PID
9
Audio PID
PCR PID
Exit
× Ø
ASTRA1
019.2 °E
0
Vertical
0
AUTO
????????
0
0
Auto