Page 1
BTL-5000 C A R T F O R D E V I C E S B T L - 5 0 0 0 S E R I E S A S S E M B L Y I N S T R U C T I O N S...
Page 2
B T L - 5 0 0 0 C a r t – A s s e m b l y I n s t r u c t i o n s M e d i c a l T e c h n o l o g i e s s . r . o . A S S E M B L Y I N S T R U C T I O N S 1 .
Page 3
B T L - 5 0 0 0 C a r t – A s s e m b l y I n s t r u c t i o n s M e d i c a l T e c h n o l o g i e s s . r . o . 1 .
Page 4
A t t a c h m e n t f o r o n e B T L - 5 0 0 0 D e v i c e Together with the attachment there are supplied components (M4x16 and peg) for fixing the BTL-5000 device to the attachment, and the manual locking bolt (M5x16) for fixing the attachment with the device in the required angle.
Page 5
B T L - 5 0 0 0 C a r t – A s s e m b l y I n s t r u c t i o n s M e d i c a l T e c h n o l o g i e s s . r . o . p a g e 5 o f 1 0...
Page 6
B T L - 5 0 0 0 C a r t – A s s e m b l y I n s t r u c t i o n s M e d i c a l T e c h n o l o g i e s s . r . o . 1 .
Page 7
By the screwdriver screw the peg into the bottom of the BTL-5000 device. • Place the BTL-5000 device on the attachment so that the peg fits into the hole on the top side of the attachment. • Align the front side of the BTL-5000 device with the front edge of the attachment.
Page 8
After unpacking of BTL vac remove the water container on the left side. • After removing the water container put BTL vac into the wooden box. • The front bottom edge of BTL vac must be aligned with the edge of the wooden box. • Put the water container back in. •...
Page 9
When moving the cart make sure that all conductors of the devices are securely attached and will not be dragged on the ground. The cables of electrodes of BTL vac shall be looped round the blue columns on the plexiglass.
Need help?
Do you have a question about the BTL-5000 Series and is the answer not in the manual?
Questions and answers