Face Database Management - Speco N8NRE User Manual

AI Event Management NVR User Manual
⑥ Enable "Save Source Information" or/and "Save Face Information" as needed. If enabled, the system will automatically save the corresponding
images on the SD card. For the models with LED light, white light mode also can be set.
⑦ Click "Apply" to save the settings.
⑧ Click "Trigger Mode" to go to face detection alarm linkage setting interface:
Face Detection Alarm Linkage Configuration:
① Trigger "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail" as needed.
Record: Click the "Configure" button to pop up the window. Select camera on the left side and then click to set the camera as the trigger
camera. Select trigger camera on the right side and then click to cancel the trigger camera. Click "OK" to save the settings. The trigger cameras
will record automatically when faces are detected.
Alarm-out: Click the "Configure" button to pop up the window. Then the "Trigger Alarm-out" window will pop up automatically. Configure the trigger
alarm-out in the window. The system will trigger the alarm-out automatically when faces are detected. You need to set the delay time and the
schedule of the alarm outputs. See 11.6.1 Alarm-out for details.
Preset: Click and then select the preset for each camera. To add presets, please see 6.2 Preset Setting for details.
Snapshot: check it. The current camera will capture images automatically when faces are detected.
Push: If it is enabled, the system will send messages when faces are detected.
Buzzer: if it is enabled, the system will begin to buzz when faces are detected. To set the delay time of the buzzer, please see 11.6.4 Buzzer for details.
Pop-up Video: if it is enabled, the system will pop up the corresponding video automatically when faces are detected. To set the duration time of the
video, please see 11.6.3 Display for details.
E-mail: if it is enabled, the system will send an e-mail when faces are detected. Before you enable the email, please configure the recipient's e-mail
address first (see 11.6.2 E-mail Configuration for details).
⑨ Click "Apply" to save the settings.

9.1.2 Face Database Management

① Click StartSettingsAI/EventAI EventFace RecognitionFace Database to go to the following interface as shown below.
50