View Mode; Display Mode - Speco N8NRE User Manual

Live View Introduction

5.2 View Mode

5.2.1 Display Mode

Set different screen modes and cameras' display sequences as needed and then save the display modes classified by surveillance areas, priorities
and so on. Refer to the picture below. Double click one display mode in the display mode list to view the live images in this mode.

Add Display Mode
Method One:
① Click "Customize Display Modes" in the above interface
② Click
to add a display mode name and then set the screen mode.
③ Add the cameras and adjust the cameras' display sequence as required.
④ Click
under the display mode list.
Method Two:
① Click StartSettingsSystemBasicOutput Settings to go to the interface and then set the screen mode.
② Double click the camera or camera group in the list to add them to the selected window.
③ Click
to save the current display mode (refer to 5.2.4 Scheme View in Sequence for detail configurations). The display mode will be saved
and displayed in the display mode list in the live preview interface.

Edit Display Mode
Click "Customize Display Modes" tab in the live preview interface and then select one display mode in the list. Click
19
NVR User Manual
to edit the display mode