ECR EMI America Series Installation, Operation And Maintenance Manual page 39

CACH/CAHH Microprocessor Controller Operation
POWER/SEND
Pressing the POWER/SEND button momen-
tarily will switch the unit either on or off.
1. In the OFF mode, the liquid crystal dis-
play (LCD) will display the time of day
and day of the week.
2. In the ON mode the LCD will also display
the room temperature, mode of operation
Cooling, Heating, Auto (Auto change-
over), Dry or Fan mode.
3. While in the ON mode, the setpoint
temperature will display momentarily
with the push of any button except the
POWER/SEND button.
4. Also, when POWER/SEND is held down
for two (2) seconds, the remote transmits
all optional Infrared Hand Held Control-
ler information to the Cassette.
Mode
NOTICE
Heating, Auto Changeover (Auto)
or Dry modes will not display if Heat
Source is set to OFF in the Configura-
tion mode.
The MODE button allows the selection of the
mode of operation — Cooling, Heating, Auto
Changeover (ACO), Dry or Fan mode.
In Fan mode either "HIGH" or "LOW" will
appear on the LCD.
Fan Operation
The indoor unit utilizes a two-speed motor
with three operational fan modes — High,
Low and Auto.
The FAN button will allow the selection of
the desired fan setting in all modes except
Dry mode.
In mode, the fan will operate constantly
Dry
at low speed. The LCD will indicate the fan
speed selection.
P/N 240007756, Rev. A [051509]
CACG/CAHG & CACH/CAHH
• Installation, Operation and Maintenance Manual •
and
High
fan operates continuously, regardless of set-
point or room temperatures.
fan mode is for auto ramping of fan
Auto
speeds.
1. Auto fan mode can only be selected if
the unit is in Heating, Cooling or Auto
Changeover modes.
2. In Auto fan mode, the speed is determined
by the microprocessor.
a.
b.
c.
Louver operation — CAHH 24 and
CACH 36 only
The louver can be set to oscillate during fan
operation or open to a fixed setting.
When LOUVER is pressed, the word "Lou",
will display for two seconds along with "ON
or "OFF" to indicate that the louver setting
has been changed.
39
Air Handlers
(continued)
are constant fan settings. The
Low
Speed adjustment will be made ac-
cording to room and setpoint tem-
peratures.
The fan will switch to High speed
when room temperature deviates
by more than two degrees from
setpoint.
The fan will switch to Low speed if the
deviation is one degree or less.
Made in the USA