Leveling The Appliance; Connecting The Water Supply Hose - LG WD1207NCW Owner's Manual

Leveling the Appliance

If the floor is uneven, turn the adjustable feet as
required (Do not insert pieces of wood etc. under
the feet). Make sure that all four feet are stable
and resting on the floor and then check that the
appliance is perfectly level (Use a spirit level).
• Once the appliance is level, tighten the lock
nuts up towards the base of the appliance. All
lock nuts must be tightened.
Raise
Lock nut
Diagonal Check
• When pushing down on the edges of the top
plate diagonally, the appliance should not move
up and down at all (check both directions). If
the appliance rocks when pushing the machine
top plate diagonally, adjust the feet again.
NOTE
• Timber or suspended type flooring may
contribute to excessive vibration and
unbalance.
• Do not install the washer on any elevated
surface, stand or plinth as it can become
unstable and fall causing serious injury and
damage.
14
Lower
Tighten all 4
lock nuts securely
Connecting the Water Supply
Hose
• Water supply pressure must be between 100 ~
800 kPa (1.0‒8.0 kgf/cm ²). If the water supply
pressure to the machine is more than 800
kPa (8.0kgf/cm² ),Please consult a plumber or
qualified person about fitting a water pressure
reduction device.
• Do not overtighten the water supply hose.
• If the water supply pressure is more than 800
kPa, a pressure limiting device should be
installed.
• Periodically check the condition of the hose
and replace the hose if necessary.
Checking the Rubber Seal on the
Water Supply Hose
Two rubber seals are supplied with each
water inlet hose. They are used for preventing
water leaks. Make sure the connection to
taps is sufficiently tight. Do not use any
mechanical device to overtighten the inlet
hoses. Hand tighten only with the aid of a soft
cloth if necessary. After both ends have been
connected, open the taps slowly and check for
leaks..
Hose connector
Rubber seal
Hose connector
Rubber seal
EN