Leveling The Appliance; Connecting The Water Supply Hose - LG F4J7VNPW Owner's Manual

Leveling the Appliance

If the floor is uneven, turn the adjustable feet as
required (Do not insert pieces of wood etc.
under the feet). Make sure that all four feet are
stable and resting on the floor and then check
that the appliance is perfectly level (Use a spirit
level).
• Once the appliance is level, tighten the lock
nuts up towards the base of the appliance. All
lock nuts must be tightened.
Raise
Lock nut
Diagonal Check
• When pushing down the edges of the top
plate diagonally, the appliance should not
move up and down at all (check both
directions). If the appliance rocks when
pushing the machine top plate diagonally,
adjust the feet again.
NOTE
• Timber or suspended type flooring may
contribute to excessive vibration and
unbalance.
• If the washing machine is installed on a raised
platform, it must be securely fastened in order
to eliminate the risk of falling off.
14
Lower
Tighten all 4
lock nuts securely
Connecting the Water Supply
Hose
• Water pressure must be between 0.1 MPa
and 1.0 MPa (1.0‒10.0 kgf/cm
• Do not strip or crossthread when connecting
supply hose to the valve.
• If the water pressure is more than 1.0 MPa, a
decompression device should be installed.
• Periodically check the condition of the hose
and replace the hose if necessary.
Checking the Rubber Seal on the
Water Supply Hose
Two rubber seals are supplied with the water
inlet hoses. They are used for preventing water
leaks. Make sure the connection to taps is
sufficiently tight.
Hose connector
Hose connector
).
2
Rubber seal
Rubber seal
EN