OWNER'S MANUAL WD13020D/WD13020D1 WD12020D Thank you for buying a LG Fully Automatic Washing machine. Please read your owner's manual carefully, it provides instructions on safe installation, use and maintenance. Retain it for future reference. Record the model and serial numbers of your washing...
roduct Features Protection against creases With the alternate rotation of the drum, creased garments are minimized. Built-in Heater Internal heater automatically heats the water to the best temperature on selected cycles. More economical by Intelligent Wash System Intelligent Wash System detects the amount of load, and then determines the optimum water level and washing time to minimize energy and water consumption.
arnings READ ALL INSTRUCTIONS AND EXPLANATION OF THE INSTALLATION BEFORE USE For your safety, the information in this manual must be followed to minimize WARNING! the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life. IMPORTANT SAFETY INSTRUCTIONS WARNING To reduce the risk of fire, electric shock, or injury to persons when using the washer,...
: 64 I Permissible water pressure : 100-800kPa (1-8 bar) I Spin speed : No Spin/400/800/1300 [WD13020D/WD13020D1] No Spin/400/800/1200 [WD12020D] I The external hot water supply MUST NOT exceed 65°C I Permissible cold water temperature : 4-25°C I No further backflow protection required for connection to the water supply.
nstallation Install or store where it will not be exposed to temperatures below freezing or exposed to the weather. Properly ground washer to conform with all governing codes and ordinances. The base opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.
nstallation Installation place requirements Level floor : Allowable slope under entire washer is 1˚ Power outlet : Must be within 1.5 meters of either side of location of washer. Do not overload the outlet with more than one appliance. Additional Clearance : Allow 10cm of clearance at the rear of the machine and 2cm at each side.
nstallation I Electrical connection 1. Do not use an extension cord or double adapter. 2. If the supply cord is damaged, it must be replaced by the manufacturer or its service agents in order to avoid a hazard. 3. Always unplug the machine and turn off the water supply after use. 4.
nstallation This equipment is not designed for maritime use or for use in mobile installations such as caravans, aircraft etc. Turn off the supply tap if the machine is to be left for any length of time (e.g. holiday), especially if there is no floor drain(gully) in the immediate vicinity. When disposing of the appliance, cut off the mains cable, and destroy the plug Disable the door lock to prevent young children being trapped inside.
• If possible install the washer in one of the corners of the room, where the floor is more stable. Insert the rubber cups to reduce vibration. You can obtain the rubber cups (p/no.4620ER4002B) from the LG spares dept. Important! • Proper placement and levelling of the washer ensure long,regular and reliable operation.
are before washing Preparations for the first wash Select a cycle (COTTON 60°C, add a half load of detergent) allow the unit to wash without clothing. This will remove residues and water from the drum that may have been left during manufacturing.
dding detergent Adding detergent and fabric softener 1. The Dispenser Drawer • Main wash only ➔ • Pre Wash + Main Wash ➔ Detergent for Fabric Detergent for main wash softener pre wash 2. Adding Fabric Softener • Do not exceed the maximum fill line. Close the dispenser drawer slowly.
dding detergent 3. Detergent dosage [Important Note] Recommended amount of detergent as per • The detergent should be used according to the wash load instruction of the detergent manufacture. Water quality and temperature will play a major part on how much detergent is required. •...
7.5 kg detergent after boiling wash ❋ WD13020D/WD13020D1 : Program setting with “ Cotton, Intensive, 40°C, 1300 rpm” option for test in accordance or in conformity with AS/NZS 2040.2 for 7.5 kg normally soiled cotton load. WD12020D : Program setting with “ Cotton, Intensive, 40°C, 1200 rpm” option for test in accordance or in conformity with AS/NZS 2040.2 for 7.5 kg normally soiled cotton load.
- Wash : main wash • Press the Start/Pause button. - Rinse : 3 times - Spin : 3. Beep on/off [WD13020D/WD13020D1] • 1300 rpm [WD12020D] • 1200 rpm - Water temperature : 40˚C - Program : Cotton •...
Delicate – Hand Wash/Wool – Bio Care – I Initial program Boiling Care – Baby Care”. • [WD13020D/WD13020D1] - Cotton Program / Main wash / Please refer to page 13 for suitable laundry types Normal Rinse / 1300 rpm / 40˚C and their maximum capacities in each cycle.
ow to use washer Start/Pause Option • By pressing the Option button, Option functions may be selected. 1. Start • This Start/Pause button is used to start wash cycle or pause the wash cycle. 2. Pause 1. Medic Rinse • If temporary stop of wash cycle is •...
ow to use washer Tub Clean Child Lock Tub Clean course can be set by pressing If you choose to lock the buttons on the and holding Intensive and Crease Care control panel to prevent tampering this button simultaneously. function may be selected. When Tub Clean course is set, the display Child Lock can only be selected once the will show “...
• After selecting the wash course, the spin speed can be chosen by pressing the spin button. [WD13020D/ [WD12020D] WD13020D1] 1. Spin selection 2. No spin • Spin Speed is available according to • If No spin is selected, the washer stops the program as follows.
ow to use washer Water Temp. Time Delay • By pressing the Temp. button, the water temperature can be selected. - Cold Preparing washing before starting “Time Delay” - 30˚C / 40˚C / 60˚C / 95˚C - Turn on the water tap. - Load laundry and close the door.
ow to use washer Display 3. Completion of washing • When washing cycle is completed, “ ” is displayed on the “Multi display”. 4. Time left 1. Special function Multi display • During the wash cycle, the remaining washing • When child lock is selected, the “ ”...
aintenance ❋ Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock to avoid electrical shock hazards. ❋ When disposing of the appliance, cut off the mains cable, and destroy the plug Disable the door lock to prevent young children being trapped inside. The water inlet filter - "...
aintenance The drain pump filter ❋ The drain filter collects threads and small objects left in the laundry. Check regularly that the filter is clean to ensure smooth running of your machine. CAUTION First drain using the drain hose and then open the pump filter to remove any threads or objects.
aintenance I Dispenser drawer ❋ After a while detergents and fabric softeners leave a deposit in the drawer. • It should be cleaned from time to time with a jet of running water. • If necessary it can be removed completely from the machine by pressing the catch downwards and by pulling it out.
aintenance I Cleaning your washer 1. Exterior Proper care of your washer can extend its life. The outside of the machine can be cleaned with warm water and a neutral non abrasive household detergent. Immediately wipe off any spills. Wipe with damp cloth. Try not to hit surface with sharp objects.
roubleshooting guide ❋ This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately When the machine does not function properly or does not function at all, check the following points before you contact your service provider.
roubleshooting guide Symptom Possible Cause Solution Washer does not start Make sure plug fits tightly in wall • Electrical power cord may not be plugged in or connection outlet. may be loose. • House fuse blown, circuit Reset circuit breaker or replace fuse. breaker tripped,or a power Do not increase fuse capacity.
roubleshooting guide Symptom Possible Cause Solution Check another tap in the house. • Water supply is not adequate in area. Fully open tap. • Water supply taps are not completely open. Straighten hose(s). • Water inlet hose(s) are kinked. Check the filter of the inlet hose. •...
erms of Warranty What Is Not Covered: • Service trips to your home to teach you how to use the product. • If the product is connected to any voltage other than that shown on the rating plate. • If the fault is caused by accident, neglect, misuse or Act of God. •...