TABLE OF CONTENTS YOUR SILEX SYSTEM ….………………………………..………1 ABOUT THE 00M10800, 00M20800 & 00M30800 MODELS ……..1 How does the Silex Deionizer work?………..….………………….1 How does the regeneration work?…...……………………….……1 About the resin pack……….…….…………..……………………….1 SILEX FEATURES…….………………………..……… INSTALLATION-COMMON SITUATIONS OF USE …3 INSTALLATION-10 EASY STEPS……..………..….
Silex is a simple, maintenance-free system. When the monitor light signals that the product water quality has dropped below the desired quality setpoint, simply exchange the resin packs and send them to AmeriWater for regeneration. NOTE: AMERIWATER DOES NOT REGENERATE RESIN PACKS THAT HAVE BEEN USED IN HAZARDOUS WASTE APPLICATIONS.
INSTALLATION IN 10 EASY STEPS Locate the Silex system on a firm, level foundation. It is recommended, but not required, to locate the system near a standard floor drain or sump. CAUTION: Vent all plumbed drain lines in accordance with local plumbing codes and / or local regulations.
Page 7
NOTE: 16 feet of hose has been provided with the Silex system. Cut the hose to the desired lengths for the inlet hose and outlet hose and install the provided fittings as needed (See Silex Hose Ass’y. drawing ). Connect the outlet hose to the hose barb fitting on the right side of the system (while facing the label).
Page 8
c. Stretch the resin pack over your arm to elongate the pack, and feed it into the Silex column allowing the pack to slide out of the plastic sleeve. d. Replace the cover plate and tighten the black knobs. Be sure to tighten the knobs evenly by screwing in the knobs in opposite corners simultaneously.
RESIN PACK & FILTER EXCHANGE Resin Pack Exchange Turn off the water supply to the Silex system. Open the air vents located in the center of the cover plates. Place a container under the Drain Valves located on the bottom plates of the system.
Filter Cartridge Replacement Carbon prefilter cartridges should be replaced each time the resin pack(s) are exchanged. Turn off the water supply to the system. Place a container under the filter housing sumps and open the filter drain ports on the bottom of the sumps to drain the water out of the filter housing.
Fill out a regeneration certificate by printing your name, phone number, company and address. When you send each pack to AmeriWater, enclose the regeneration certificate in the box. AmeriWater will ship you a freshly regenerated resin pack. To order more certificates, contact the company that originally sold you the deionizer.
Warranty Policy The buyer has a lifetime warranty on the PVC housing and a one year warranty on all other equipment and parts, excluding non-durable components (e.g., resin packs, carbon packs, filter cartridges, and water quality monitors); provided that the system is not subject to abuse, misuse, alteration, neglect, freezing, accident or negligence;...
Page 16
(PVC). The AmeriWater system you have purchased may contain PVC or stainless steel parts. While warnings are only required in the State of California, AmeriWater has initiated the use of Prop 65 labeling for all products to ensure compliance with California regulations. Please note that the above warning does not necessarily mean that the product that you have purchased is unsafe.
Need help?
Do you have a question about the 00M10800 and is the answer not in the manual?
Questions and answers