Rtcdt; Optional Signal; Tx Power; Offset - Alinco DJ-MD5X Operation Manual

6.RTCDT

Set up the CTCSS/DCS code for both TX and RX CTCSS code: 62.5Hz~254.1Hz, a
total of 51 groups DCS code: 000N~7771, a total of 1024 groups.

7.Optional Signal

Allows the set up of DTMF/5TONE/2TONE encode and decode for the analog channels.

8.TX power

Refer to digital channel setting

9. Offset

Allow to set the offset frequency for transmit frequency

10.Squelch mode

When the analog channel is set up for both CTCSS/DCS decoding and optional
signaling, you can set up the RX condition in this menu.
SQ: You can hear the call when the channel receives a matched carrier.
CDT: You can hear the call when the channel receives a matched CTCSS/ DCS signal
TONE: You can hear the call when the channel receives a matched signaling.
C&T: You can hear the call when the channel receives a matched CTCSS/ DCS and
matched tone signaling.
C|T: You can hear the call when the channel receives a matched CTCSS/ DCS or
matched signaling

11.Band Width

Choose wide band or narrow band for the analog channel.

12.Reverse

When this function is enabled, the RX frequency, TX frequency and CTCSS/DCS
encode/decode will be reversed.

13. RX Frequency

Refer to digital channel setting

14.TX Frequency

Refer to digital channel setting
33