Table of Contents
Advertisement
NOTES TO USERS
Thank you for purchasing Carrier Absorption Chiller.
Before operating the Chiller, please read this manual thoroughly.
Please utilize the Chiller to its optimum performance by following recommended daily maintenance and handling, and
periodic service.
If you need any information about maintenance contract or any other inquiries, please contact Carrier service agent.
DECLARATION OF CONFORMITY < for CE marking model >
This product is marked " CE " as it satisfied EEC Directive No. 2006/42/EC, 2014/30/EU, 97/23/EC, 2009/142/EC and
conforms with following standards.
This declaration will become void in case of misusage and/or from non observance though partial of Manufacturer's
installation and/or operating instructions.
Class and group description (EN 55011, clause 5.1)
This is group 1, class A product according to EN 55011. This means that this product does not generate and/or use
intentionally radio-frequency energy, in the form of electromagnetic radiation, inductive and/or capacitive coupling, for the
treatment of material or inspection / analysis purpose and that it is suitable for use in all establishments other than domestic
and those directly connected to a low voltage power supply network which supplies buildings used for domestic purposes.
Statement for Class A Equipment (EN 55011, clause 5.3)
This is a class A product. There may be potential difficulties in ensuring electromagnetic compatibility in environments other
than industrial, due to conducted as well as radiated disturbances.
Cable Specification and Equipment Orientation (EN 55011, clause 7.5.2 and EN 61000-6-2)
Refer to the "Field wiring" section of the Installation manual.
CE Marking and Apparatus Identification (2006/42/EC, clause 16.2 and 2004/108/EC, clause 8.1)
There are printed on the nameplate of the chiller control panel.
Name and Address of Manufacture
Refer to the document of Declaration of conformity.
Statement for Equipment for witch Compliance with the Protection Requirements is not ensured in Residential Areas
(EMC Directive 2014/30/EU, clause 9.4)
- This product must not be used in residential areas.
- This product may cause interference if used in residential areas. Such use must be avoided unless the user takes
special measures to reduce electromagnetic emissions to prevent interference to the reception of radio and television
broadcasts.
UL CERTIFICATION < for UL marking model >
This product has met the necessary design and construction qualifications for certification per Underwriters'
Laboratories. Each machine carries a UL listing and is labeled accordingly.
PRODUCT PROFILE
(1) Excellent for peak shaving during high electrical demand periods.
(2)
Designed to provide chilled water from waste heat sources, generated from industrial processes and
cogeneration systems.
(3)
Allows diversification of critical cooling requirements. Critical cooling loads are met with minimal electrical power
input with a hot water-fired chiller.
(4)
Allows for smaller generator set installation be utilized since the electrical load associated with an absorption
chiller is minimal when compared to an electric chiller.
(5)
Ozone safe, CFC free. Cooling requirements are met without chlorine based refrigerants.
(6)
Reduces effectors to global warming. Minimizes global impact by greatly reducing electricity consumption and
eliminating the use of greenhouse gases.
(7)
Environment: Molybdate solution inhibitor is used with no impact on environment.
(8)
Low noise and vibration. The absorption chiller dose not utilize a large motor-compressor, and this leads to quiet,
trouble-free operation.
(9)
Small footprint saves facility space.
USE OF PRODUCT
Absorption Chiller is air conditioning equipment achieving comfortable space, energy saving, and economic efficiency.
It has been used in office buildings, hotels, department stores, hospitals, schools, convention centers, government
building, etc.
Note: The contents of this manual are subject to change without notice.
Advertisement
Table of Contents
