Stopping Engine; Procedure For Single Station Models; Procedure For Dual Station Models (Main Station); Procedure For Dual Station Models (Sub Station) - Yamaha F300 Owner's Manual

Operation
EMU27821

Stopping engine

Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU35801

Procedure for single station models

1. Turn the main switch to "
ON
OFF
OFF
ON
OFF OFF
76
" (off).
START
ZMU06247
ON START
ZMU04599
ON
ZMU05833
ON
OFF OFF
2. Remove the key if the boat will be left
unattended.
TIP:
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to " " (off).
EMU35930
Procedure for dual station models
(main station)
1. The procedure until stopping the engine
is the same as that of the single station
models.
2. Remove the key if the boat will be left
unattended.
TIP:
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to " " (off).
EMU35910
Procedure for dual station models
(sub station)
Push and hold the red engine stop button un-
til the engine comes to a complete stop.
When the engine has been stopped from the
sub station, be sure to turn the main switch
on the main station to "
ON ON
OFF
ZMU06014
".