Setup By The Printer Driver; Using The Finisher Functions In The Copy Mode - Sharp AR-FN7 Service Manual

2. Setup by the printer driver

A. Setup procedures when the staple function is used
1) Select "PROPERTIES" in the setup menu of the printer driver.
2) Click the "MAIN" tab.
3) In the "FINISH" item, select "Stapling position" and "Staple."
B. Setup procedures when the saddle stitch function is used
1) Select "PROPERTIES" in the setup menu of the printer driver.
2) Click the "MAIN" tab.
3) In the "DUPLEX PRINT" items, put a check mark to the radio button of "Center binding."
4) Select between the normal-ratio center binding and 2-UP center binding.
5) In the "FINISH" item, select "2-position binding" of "STAPLE."
C. Setup procedures when the punch function is used
1) Select "PROPERTIES" in the setup menu of the printer driver.
2) Click the "MAIN" tab.
3) In the "FINISH" items, put a check mark to the check box of "PUNCH."

3. Using the finisher functions in the copy mode

If you touch the [OUTPUT] key on the copy mode basic screen, a screen for selecting the sort/group/staple functions and selecting an exit tray will
appear.
1. [GROUP] key
If this function is selected, all copies of the same original will be grouped.
2. [STAPLE SORT] key
If this function is selected, sorted copies will be stapled and delivered to
the offset tray. (not offset stacked)
3. [SORT] key
If this function is selected, each set of copies will be sequentially
delivered.
4. Icon display
The icon of the selected function (sort, staple sort, group or saddle
stitch) is displayed.
5. [OFFSET TRAY] key
If the offset tray is selected, printed sheets will be delivered to the offset
tray. (If the staple sort function is selected, the offset tray will be
automatically selected.)
6. [CENTER TRAY] key
If the center tray is selected, printed paper will be delivered to the exit
tray located at the upper part of the main unit.
1 2 3 4 5
OUTPUT
SORT
STAPLE
SORT
GROUP
AR-FN7/PN1 MACHINE OPERATION 7-2
6
OFFSET CENTER
TRAY TRAY
SADDLE
STITCH
OFFSET
8
7. [OK] key
Press to close this screen and to return to the basic screen.
8. [OFFSET] key
If this function is selected (checked), the offset function will be enabled. If
the check mark is cleared, the offset function will be disabled. (If the
staple sort function is selected, the check mark of the offset function will
be automatically cleared.)
9. [SADDLE STITCH] key
Printed paper will be stapled at the center and folded in two with the
center down. If this function is selected, the pamphlet copy function (see
page xx of the copier operation manual) will be automatically set.
10. [PUNCH] key
If a punch module is installed, printed paper can be punched.
* If a function is selected, the corresponding key will be highlighted.
7
OK
PUNCH
9 10