Sharp AR-FN7 Service Manual page 42

(12)Removing the Stack delivery roller (lower)/Delivery Belt
1) Remove paddle assembly, and separate it from the processing tray
assembly. (See 1.B.(4).)
2) Slide the aligning plate (front) [2] and the aligning plate (rear) [3] of
the processing tray assembly [1] by sliding them to the outside.
[3]
Fig.F03-102-49
3) Remove the processing tray stopper [4].
Fig.F03-102-50
4) Remove the screw [5], and detach the paper guide (front) [7] while
freeing the two claws [6].
[6]
Fig.F03-102-51
5) Remove the screw [8]; then, while freeing the claw [9], detach the
paper guide (rear) [10].
[10]
[9]
Fig.F03-102-52
[1]
[2]
[4]
[5]
[7]
[8]
AR-FN7/PN1 DISASSEMBLY AND ASSEMBLY 5-11
6) Remove the two stop rings [11]; then, move the two bushings [12] to
the inside.
[12]
[11]
Fig.F03-102-53
7) Remove the four screws [13]; then, lift the stack delivery roller
assembly (lower) [14] to detach.
[13]
[14]
Fig.F03-102-54
8) Remove the stack delivery roller (lower) [15] and the two delivery
belts [16].
[15]
Fig.F03-102-55
NOTE: Be sure to mount them so that the edges [17] of the claws of the
delivery belts are flush.
Fig.F03-102-56
[11]
[12]
[13]
[16]
[17]