Sharp AR-FN7 Service Manual page 9

5) Install the staple unit to the finisher.
<1> Remove the two pieces of packing tape from the locations shown in
the illustration.
Packing tape
<2> Open the front cover of the finisher and insert the staple unit.
6) Attach the cover to the finisher.
<1> Attach the plate R to the position shown in the illustration and
secure it using two screws A.
<2> Attach the front cover to the finisher, and secure the upper part
using two screws B and the lower part using two screws A.
Front cover
Screws B
Screws A
Screws A
Packing tape
Plate R
AR-FN7/PN1 UNPACKING AND INSTALLATION 3-2
7) Connect the finisher to the stand/paper drawer.
<1> Remove the cover from the finisher stand.
<2> Attach the connecting plate to the finisher using two screws A.
<3> Reattach the cover to its original position.
Screws A
Connecting plate
<4> Cut out the two mounting holes for the connecting plate at the lower
part of the stand/paper drawer in a similar way to step 3).
<5> Attach the finisher connecting plate to the stand/paper drawer using
two screws C.
Screws C
8) Check and adjust the height of the finisher.
Move the finisher toward the printer and check to see if the guide pin
of the locking plate is inserted smoothly to the connecting hole of the
finisher.
Cover
Finisher stand
Stand/paper drawer
Connecting plate
Connecting
hole
Guide pin