Troubleshooting - Panasonic KX-TG2340JX Operating Instructions Manual

Pulse-or-tone dialing capability
Table of Contents

Advertisement

PQQX14670ZA.book 55 ページ 2005年2月22日 火曜日 午後12時0分

Troubleshooting

If the handset display shows error messages, see "If the Following Appear on
Your Display..." (p. 54) for the Cause & Remedy.
Problem
"No link to base. Move
closer to base, try
again." is displayed and an
alarm tone sounds.
The handset and/or base unit
does not work.
Static, sound cuts in/out,
fades. Interference from other
electrical units.
The handset and/or base unit
does not ring.
The handset display is blank.
You cannot program any
function items.
Cause & Remedy
• You are too far from the base unit. Walk
closer to the base unit.
• Confirm the base unit's AC adaptor is
plugged in.
• Raise the base unit antenna.
• If the above remedies do not solve the
problem, the handset may have lost
communication with the base unit. Register
the handset again (p. 49).
• Check the settings (p. 8–10).
• Check whether the dialing mode setting is
correct (p. 14).
• Fully charge the battery (p. 9).
• Clean the charge contacts and charge again
(p. 10).
• Check battery Installation (p. 9).
• Unplug the base unit's AC adaptor to reset it.
Plug in, and try again.
• Re-install the battery (p. 9) and fully charge it.
• Move the handset and base unit away from
other electrical appliances (p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
• If the unit is connected to a telephone line
with DSL service, you may hear noise from
the receiver or speaker during conversations.
We recommend connecting a noise filter
(contact your DSL service provider) to the
telephone line between the unit and the
telephone line jack.
• The ringer volume is turned off. Set to high,
medium, or low (p. 16, 17).
• If the handset display is blank, fully charge
the battery (p. 9).
• Programming is not possible while the
handset and/or base unit is being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
• When the Dial Lock is turned on (p. 47), you
cannot store the phone number in the phone
book.
55

Advertisement

Table of Contents
loading

Table of Contents