Use in hazardous, explosive atmospheres is prohibited. This manual covers the Baumalight Brush Mulcher, models MS548 and MS560. Use the Table of Serious injury or death of the operator or bystanders Contents as a guide to locate required information. may be caused if the tool is misused. Misuse may...
2 SAFETY 2.1 Safety Alert Symbol 2.2 Operational Hazards and Safety Words You must read, understand and follow the ^ WARNING instructions given operating unit Prevent serious injury or death� manufacturers, as well as the instructions in this manual. Read and understand this manual before The safety information in this manual is denoted operating brush mulcher�...
• NEVER allow passengers on brush mulcher. gov. If you do not understand any part of this manual, Lower Operating Speed contact Baumalight at 866-820-5603. • Lower operating speed while loading, unloading or performing heavy operations. • Keep load low and move at slow speeds on...
Avoid Rollover Relieve hydraulic pressure before disconnecting hydraulic hoses. See your skid steer Operator’s Manual. The equipment may rollover, resulting in death or serious injury. To help prevent rollover: Raised Attachment • Travel at a slow speed. • Avoid sharp turns & sudden movement on ^ WARNING slopes.
Hazards From Modifying Avoid High Pressure Equipment Fluids ^ WARNING Do not make any alterations to your brush mulcher. Altering the equipment may cause unsafe Pressurized fluids can penetrate the conditions and may void the manufacturer’s skin� warranty. Hydraulic hoses can fail from age, Avoid Wood Dust...
Engage parking brake� Do not make unauthorized modifications. Contact Baumalight at 866-820-5603 before you weld, cut/ Turn engine off and remove key� drill holes, or make any other modifications. Place “Do Not Operate” tag on control Always use Baumalight replacement parts.
3.2 Safety Signs - MS560 Dashed line indicates item hidden from view unless cover is removed. NS - Non-Slip Pad A. MTB-178 Safety Sign B. MTB-176 Safety Sign...
Page 13
C. MTB-177 Safety Sign E. MTB-185 Safety Sign F. MTB-182 Safety Sign D. MTB-175 Safety Sign...
4 INITIAL SETUP 4.1 Hydraulics 4.3 Maximum Allowable ^ WARNING Case Pressure Pressurized fluids can penetrate the skin� A450 - 500 psi, no case drain required. Disconnect and lock out power source B550 - 250 psi, case drain required. before disconnecting and/or connecting C510 - 100 psi, case drain required.
5 OPERATION 5.1 Preparation for Use Review and understand this manual and operating ^ WARNING unit manual. Remove any masking materials affixed during Wear an approved respirator (N95 Type painting. Inspect the mulcher and any accessory as a minimum)� equipment to verify that nameplates and all safety warning, caution signs and decals provided with Follow local,...
5.3 Machine Components A. Hydraulic Motor B. Operators Manual Storage Tube C. Push Plate D. Cutting Teeth E. Rotor F. Push Bar G. Debris Guard H. Quick Attach MS548 MS560...
5.5 Detach From Skid 5.4 Attach To Skid Steer Steer ^ WARNING ^ WARNING Prevent serious injury or death caused To prevent injury or machine damage by unexpected movement: put transmission in “Park”� Park skid steer on a level surface� 1�...
5.7 Carbide Teeth Break- • The machine is equipped with a push plate and During the first few hours of use, avoid hitting a push bar to push brush or small trees over. stones as much as possible to allow the carbide This will allow the mulcher teeth to contact the teeth (A) to wear slightly.
5.9 Field Operation 1. Attach brush mulcher to skid steer. See Attach ^ WARNING Brush Mulcher To Skid Steer in this section. Prevent serious injury or death caused ^ WARNING by unexpected movement: Prevent serious injury or death� Park skid steer on a level surface� 1�...
5.10 Clearing Jams If the rotor stalls, stop rotor motion and raise slightly and try again. 1. If still stalled, lower unit so teeth tips dig slightly into sod. 2. Reverse hydraulic flow. A freewheeling check valve will let the pressure pass, but you still must do this to open the hydraulic lock on the rotor.
6 SERVICE And MAINTENANCE 6.1 Maintenance Maintenance Chart General Inspection Inspect the unit for any buildup of contamination Daily (dirt, stones, etc.). Cutting Teeth Check and replace one at a time as necessary. Every 4 hours. With daily use expect to replace 4 to 6 teeth per day.
6.3 Check Belt Tension Note: The MS548 is shown in this procedure. The 8. Close inspection cover (A). Do not operate procedure is the same for the MS560. mulcher with cover (A) open or removed. 1. Lower mulcher to ground.
6.4 Replace Belt Note: The MS548 is shown in this procedure. The 10. Install washer (C) and shaft bolt (B). Tighten procedure is the same for the MS560. bolt. 11. Align pulley holes with non threaded holes in 1. Lower mulcher to ground.
5. Remove locknut (B) and tooth (A). Install new tooth. 6. Tighten locknut (B) to 150 lb/ft (204 Nm) of torque. Order replacement seal kit from Baumalight and follow instructions provided with kit. Motor Shaft Seal Replacement manual can be found at www.baumalight.com/support...
7 TROUBLESHOOTING PROBLEM CHECK SOLUTION Rotor does not spin. Rotor jammed. Remove material from rotor. See Clearing Jams. Low oil level. Check oil level in skid steer. Add if necessary. Low oil flow. Check flow control on skid steer. See your dealer.
8 STORAGE 8.1 Storing Mulcher 8.2 Removing Mulcher From Storage 1. Store mulcher in a dry place. 1. Review Operator’s manual check 2. Clean mulcher thoroughly. Dirt and wood chips adjustments. will draw moisture and cause rust. 2. If parts have been replaced, verify they run 3.
9 WARRANTY This product is warranted to be free of defects in materials and workmanship under normal use and service, for a period of one year from the date of purchase, when operated and maintained in accordance with the Operating and Maintenance Instructions supplied with this unit. This warranty does not cover misuse or negligence.
Page 28
For parts, specifications and the latest machine information please visit our website. www�baumalight�com MTB MFG INC. CORPORATE HEADQUARTERS 4575 Powell Rd., Wallenstein, Ontario Canada N0B 2S0 Phone - 519.698.9864 Toll Free - 866.820.5603 Fax - 519.698.1087 www�baumalight�com...
Need help?
Do you have a question about the MS548 and is the answer not in the manual?
Questions and answers