Installation; Connections; Connecting Dmx Signal - Flash FL-202 BEAM 5R Manual


AC IN: powerCON

AC OUT: powerCON

DMX IN: XLR - 3 pin, XLR - 5 pin

DMX OUT: XLR - 3 pin, XLR - 5 pin

IP Rating: IP20

Housing made: ABS

Cooling: Active

Height [cm]: 51

Width [cm]: 40

Depth [cm]: 32

Weight [kg]: 15

Weight with packaging [kg]: 17

Set includes: Power cord, Power cord (LINK), Mounting bracket (2pcs), XLR cable
4

INSTALLATION

After removing the packaging, check if the device was not damaged during transport. Before connecting to
the mains, make sure that the device is securely mounted. The manufacturer is not responsible for damage
caused by unstable mounting.
Ensure proper connection to the mains and proper grounding. Make sure that the electrical parameters are
consistent with device requirements. All activities, including connecting the device to the mains must be
performed by qualified personnel.
5

CONNECTIONS

The device is equipped with the following interfaces:
1. DMX (in/out): XLR 5-pin, XLR 3-pin socket
2. Power (in/out): powerCON socket
5.1

Connecting DMX signal

The connection is
CAUTION: At the last fixture, the DMX signal has to be terminated with a terminator. Solder a 120 resistor
between signal (-) and signal (+) into a XLR plug and plug it in the DMX output of the last fixture.
www.flash-butrym.pl
performed using cable with XLR-female -> XLR-Male plugs.
4