Table of Contents
Advertisement
INSTALLATION
Electrical Connections
Must be installed, maintained and removed by authorised
persons in accordance with AS/NZS 3000 and all other
WARNING
relevant local regulations and municipal building codes
including OH&S requirements.
Ensure electric wiring is installed properly. Improper
installation may cause malfunction, fire, or electric shock.
The unit must be earthed following local electrical codes.
1.
Open the front panel.
2.
Remove the wiring cover.
3.
Insert the electrical cable(s) through the bottom side at the back of
indoor unit.
4.
Secure the cable onto the control board with the cable clip.
5.
Connect the cables as shown on the drawing to the corresponding
terminals.
6.
Re-install the wiring cover.
7.
Close the front panel.
Wall Installation
1.
Remove the two foam shipping blocks from the rear of indoor unit as shown.
2.
Position the piping as shown on the drawing.
3.
Tape the refrigerant pipes, electric cable(s) and drain hose. Ensure the water drain hose is located at the
lowest side of the bundle.
Available connection
=
installation routing
Right connection
access cutout
Plastic strap
* The drain pipe is dual handed and may be installed to either the left or right of the appliance.
1. To use this option unclasp the drain hose.
NOTE
2. Unscrew the rubber plug from the alternate drainage discharge connection point.
3. Clip the drainage hose into the alternate discharge connection point.
4. Screw the rubber plug into the unused drainage discharge connection point.
Rinnai
Left connection
Electrical
Cable(s)
Liquid pipe
Vapour
pipe
Drain pipe*
access cutout
Foam shipping block
Plastic strap
Connections cross-section
10
Front-Panel
Bottom Frame
Electrical Cable(s)
HINRJ80B ONLY
All Other Models
L
N
S
S
Cable Clip
Cable Clip
Electrical Cable(s)
Electrical Cable(s)
Drain pipe*
Drain pipe*
Vapour / Liquid pipes
Electrical
Cable(s)
Mid-Frame
N LO
L
Foam
shipping
block
Split AC IM
Advertisement
Table of Contents
