HARDWARE RESOURCES BPO2 Series Installation Instructions

IMPORTANT:
Before you begin, make sure you familiarize yourself with all the
parts and fully read the instructions.
CUSTOMER SERVICE:
Toll-free customer help line available weekdays between
7:00am and 6:00pm Central Time at 800-463-0660.
TOOLS NECESSARY:
Screw gun or Phillips screwdriver and tape measure. NOTE: If
screw gun has a clutch, set to lowest setting so as not to over
tighten and/or strip screws.
PARTS IDENTIFICATION:
D
B
C
A
A Mounting Base
B Base Pullout Unit
C #10 x 3/4" Pan Head Wood Screw
D #8 x 5/8" Pan Head Wood Screw
E #8 x 5/8" Flat Head Wood Screw
Base Pullout
Installation Instructions
for the BPO2 Series
BPO2-8
14-1/2"
2"
E
Front plywood runner
1 pcs
1 pcs
Place the entire unit into the cabinet. In framed cabinets, center the unit in the opening making sure the front plywood runner is
4 pcs
pulled tight against the back of the face frame. For frameless cabinets, place the unit within 1-1/2" of the left of the cabinet and the
4 pcs front plywood runner needs to be set back 3/4". The top of the unit should be flush with the face frame. If the unit is sticking out or is
setback by more than 1/4", place a shim under either the front or the back plywood runner to make it flush.
4 pcs
Bottom Measurements
NOTE: Illustrations for measurement only. Installation of brackets and mounts will begin in Step 3
• BPO2-11 • BPO2-14
B
A
Part # A B
BPO2-5 2-9/16" 2-27/32"
BPO2-8 2-17/32" 1-1/4"
BPO2-11 4-23/32" 2-3/8"
BPO2-14 7-23/32" 3-7/8"
STEP 1 - Determine Mounting Location
Rear Bracket Measurements
BPO2-5
11/32"
A
B
2"
1-3/4"
14-1/2"
15/16"
2"
1"
Face frame
Front plywood
runner
1-3/16"
1-5/32"
Flush with face frame