HARDWARE RESOURCES CDM-WBM Installation Instructions

Installation Instructions (All Unit Sizes)
CDM-WBM
Wood Bottom-Mount Soft-Close
Trashcan Pullout with Door Brackets
IMPORTANT:
Before you begin, familiarize
yourself with all of the parts and
fully read the instructions.
CUSTOMER SERVICE:
Toll-free customer help line available weekdays from 7:00 am to 6:00 pm Central Time
at 800-463-0660.

1. Remove cabinet door if necessary

If the cabinet door is attached to the cabinet with hinges,
remove the door and hinges to prepare for organizer
installation.

3. Position the base in the cabinet

PARTS:
Pre-Assembled Organizer and Base Unit
4 - #8 x 1" Coarse-Thread Wood Screws
4 - #6 x 1/2" Coarse-Thread Screws
4 - 3M™ Double-Sided Foam Tape Squares
8 - #8 x 5/8" Coarse-Thread Screws
2 - Door Joining Brackets
(21" units only)
Scan QR or visit link to
view installation video:
https://delivr.com/2ytsf
(21" units only)

2. Separate the organizer from the base

Press the clips under the trash organizer to release pre-
installed slides, separating the organizer from the base.
Place the base unit inside the cabinet. Position it left to right,
ensuring proper clearance for hinge or door protrusion.
a. Face Frame Applications: Pull the wooden runner to the
front of the cabinet until it is tight against the back of the
face frame.*
b. Frameless Applications: Position the wooden runner with a
3/4" setback from the front of the cabinet.
* For narrow door applications, unit may have to be placed inside and
positioned with slides directly behind face frame.
TOOLS NEEDED:
Screw Gun* or Phillips Screwdriver
Measuring Tape or Ruler
Pencil
Level
*NOTE: If screw gun has a clutch, set
to lowest setting so as not to over
tighten and/or strip screws.