HARDWARE RESOURCES 1523 Instruction Sheet

Wardrobe Lift
Instruction Sheet
Adjustable Wardrobe Rail needs to be locked:
Once the Mounting Boxes are mounted to the side panels and Adjustable Wardrobe Rail is extended to the proper width,
twist the outer sleeves of the Adjustable Wardrobe Rail in opposite directions to lock in the width.
Over or under extending the width of the Wardrobe Rail may create binding with the vertical arms. (See step 4 in the
mounting instructions).
Not Locking the width may also cause the Wardrobe Rail to bend or bow.
Bumper Brackets:
Be certain Bumper Bracket are mounted on both sides before operating lift. Failure to do so will cause damage to the plastic
Mounting Boxes. (See step 1 in the mounting instructions).
Operating tips:
Cycle the lift. Once the lift is installed, cycle the unit three to five times to loosen the pistons to allow for smooth operation.
Handle pole needs to be located in the center of the Wardrobe Rail and pulled straight down and not at an angle. This will
avoid binding and ensure proper operation of the lift. Pre-installed O-rings keep the T-Bracket in position.
Assist the lift when lowering. When lowering the lift, assist the Handle Pole until the vertical arms rest on the Housing
Bumpers. Letting the lift drop on its own may cause damage to the housing.
Distribution and Weight Limit. Loading the lift with more weight than the weight limit will cause damage to the lift.
Distribute weight of clothes evenly across the Wardrobe Rail to avoid racking.