Advertisement
ADDITIONAL REMOTE FEATURES:
The two way remote control unit allows you to access status information from the vehicle, check
temperature, light the display, toggle the transmitter from beep tones to vibrate mode, initiate
daily start timer, and temperature start. Selection of these and other features are shown below:
NOTE: Transmitter must be within operating range of the vehicle, approximately 2500ft.
Check Vehicle Status
Press the lock+key+option buttons simultaneously for 1 second. The vehicle's alarm will display
the systems current status.
Check Temperature (Only available on certain remote start units)
Press the option+key buttons simultaneously for 1 second. The vehicle's alarm will
display the temperature.
Temperature is read from the alarm's module located below the dashboard. This read-
ing may be higher than actual ambient temperature due to the greenhouse effect and is relative
only to the inside vehicle temperature.
Temperature Start Mode (Available on certain models)
To toggle this feature on or off, from the armed mode, press the Option & Unlock Buttons simul-
taneously, the temperature icon appear on, or disappear from the display, and the transmitter will
emit a tone.
NOTE: This feature must be active in the feature selection menu of your system. Check with
your installing dealer to insure this feature is set to the on position if available on your system.
Light The Display
Press and release the "F" (Function) button one time. The display will illuminate for 10 seconds.
Vibrate Or Tones
Press the "F" and unlock buttons simultaneously to toggle this feature on and off.
Daily Start Timer (Only available on certain remote start units)
24 Hour Start Timer. Standing at the vehicle at the time you want it to start, press
the option + lock buttons simultaneously for 1 seconds. The transmitter will beep and
display the 24 hr timer. This is the time the vehicle will start when you follow the exit
24
procedure. In other words, if you want the vehicle to start 6AM, at 6AM of any morning,
standing at the vehicle, press and hold the option + lock buttons until you hear a beep
and the 24 hr timer is displayed. This establishes a starting time.
The Remote Start unit will start at the prescribed time once only.
This function must be activated by following the procedure below each time you want the vehicle
to start at the prescribed time. To activate this function,
(a) Turn the ignition switch off.
(b) Within 10 seconds of step (a), depress and hold the brake pedal, while pressing the key icon
transmitter button 2 times.
(c) the unit will emit 2 chirps, the transmitter will beep and the 24 Hour start timer icon on the
display will remain on.
The vehicle will start at the set time 24 hours from when set.
To toggle this feature off, press the option + lock buttons simultaneously until a beep is heard
and the 24 hr timer turns off.
NOTE: The unit will start once and run for the prescribed time. If you require more frequent
starting please refer to auto start up timer mode found in the installation guide.
Page 4
128-9456
Page 4
Advertisement
