Serial Port; Ps/2 Port; Docking Port; External Floppy Disk Drive Port - Fujitsu S Series.book User Manual

L i f e B o o k S S e r i e s – S e c t i o n F o u r

SERIAL PORT

The serial port, or COMM port, located on the Port
Replicator allows you to connect serial devices, such as
printers or scanners. In order to connect a serial inter-
face device follow these easy steps: (See figure 4-16 on
page 59 for location)
1. Align the connector with the port opening.
2. Push the connector into the port until it is seated.
3. Tighten the two hold-down screws, located on each
end of the connector.

PS/2 PORT

The PS/2 port located on the Port Replicator allows
you to connect an external keyboard, and/or numeric
keypad and mouse. In order to connect a PS/2 interface
device follow these easy steps: (See figure 4-16 on page 59
for location)
1. Align the connector with the port opening.
2. Push the connector into the port until it is seated.
P O I N T
A mouse, keyboard, or keypad may be installed and
automatically recognized by your notebook without
restarting or changing setups.
P O I N T
The use of two PS/2 devices simultaneously from the
port requires a PS/2 splitter.

DOCKING PORT

The docking port is used for the connection of your
notebook to an optional port replicator or docking
station. In order to connect your notebook to one of
these devices follow the instructions that came with your
docking port. (See figure 2-9 on page 15 for location)

EXTERNAL FLOPPY DISK DRIVE PORT

The external floppy disk drive port is used for attaching
an optional external floppy disk drive or an optional
modular floppy disk drive with the optional floppy
cable. In order to connect a external floppy disk drive to
your notebook follow the instructions that came with
your external floppy disk drive. (See figure 4-16 on
page 59 for location)
62

UNIVERSAL SERIAL BUS PORT

The Universal Serial Bus port (USB) allows you to
connect USB devices such as external game pads,
pointing devices, keyboards and/or speakers. In order
to connect a USB device follow these easy steps: (See
figure 4-16 on page 59 for location)
1. Align the connector with the port opening.
2. Push the connector into the port until it is seated.
C A U T I O N
Due to the ongoing changes in USB technology
and standards, not all USB devices and/or drivers
are guaranteed to work.

INFRARED PORT

The Infrared IrDA 1.1 (4Mbps) port allows for wireless
data transfer between your notebook and other IrDA-
compatible devices, such as another computer or a
printer, without the use of a cable. (See figure 2-8 on
page 14 for location)
It is important to keep in mind that while carrying out
this form of communication, both devices must be
placed so their infrared ports are directly facing each
other without obstruction. The devices must also be
separated by at least 6" but no more than 36" for
maximum performance.
The following conditions may interfere with infrared
communications:
A television, radio remote control unit, or a wireless
headphone is being used nearby.
Direct sunlight, fluorescent light, or incandescent light
shines directly on the port.
C A U T I O N
Do not move either device while communication is
active as it may interrupt data transmission.
C A U T I O N
Be careful not to scratch the infrared port lens.
Scratches, dirt, or other surface marks can
degrade operation.