BQS BSFIX123 Instruction Manual page 23

3. Pull the iSoFiX adjuster (7) to extract both arms
(18). Move the locking arms from side to side until
you hear the click indicating that they are fully
locked (fig.11).
* The insertion guides facilitate the installation of
the safety seat with the aid of the iSoFiX securing
points and prevents damage to the upholstery.
When not in use they should be removed and stored
in a safe place. in vehicles with a reclining back the
insertion guides should be removed before the seat
is reclined. Problems that may arise are generally the
result of accumulation of dirt or foreign bodies in the
insertion guides and the clasps. To solve this type of
problem simply clean the part in question.
5. INSTALLING THE SEAT, GROUP 1
GROUP 1 Only
NOTICE
9 to 18 Kg.
1. Make sure the 5-point harness of the safety seat has
been correctly installed (see section 3).
2. Follow the steps described in section 3.1.
3. Follow the steps described in points 3.10.
4. Take the Top Tether and pass it over the safety seat.
5. Place the safety seat on the vehicle seat facing in the
direction of travel.
6. Hold the safety seat with both hands and insert the
two locking arms (19) firmly into the insertion guides
44
(18) iSoFiX
fig. 11
locking
arms.
(7) iSoFiX
Adjuster.
7
18
fig. 12
OK
CLICK
16
fig. 13 fig. 14
(32) until they fasten with a click on both sides. The
red button will partially change to green on both
sides (fig. 11).
7. Shake the seat to check that it is correctly anchored
to the vehicle's iSoFiX points (fig. 13).
IMPORTANT! The locking arms are only correctly fixed
if both safety buttons are partially green.
8. Pull the iSoFiX adjuster and push the safety seat
towards the back using a firm, constant pressure
on both sides until it rests firmly against the vehicle
seat.
9. Take the Top Tether and press the Top Tether adjuster
(13) to stretch the strap (fig. 14).
fig. 15
fig. 16
34
(34) Green tension indicator
45