BQS BSFIX123 Instruction Manual page 20

2. USES IN THE VEHICLE
WHERE:
in the vehicle rear seats.
Please, do noT install the safety seat in
forward seats except for the following cases:
1. Whenever the vehicle does not count with
rear seats.
2. When all rear seats are already occupied by
children exceeding 135 cm height.
3. When it is not possible to install all child
restraints systems in the rear seats.
HOW:
GRoUP 1 / install forward facing.
GRoUP 2-3 / install forward facing.
On seats with:
iSoFiX hooks (between the seat and the
seat back) and Top Tether anchorage points
(such as on the rear shelf, on the ground or
behind the seat) and a 3-point seatbelt (car
seatbelt)
NOTICE:
The child seat must only be used in this seat
iF it has a lap and diagonal belt (3 points).
38
1
1
2
2
The seat offers a number of assembly options. The
following table shows the installation types for each
group:
GROUP SEAT CHILD MANUAL
INSTALLATION INSTALLATION CHAPTER
Isofix + Top 5-point
1 (9-18 kg) 5
tether harness
Cinturón
2 (15-25 kg) Isofix 6
del vehículo
Cinturón
3 (22-36 kg) Isofix 6
del vehículo
3. GENERAL SEAT USE
3.1. How to use the harness buckle
1. Bring the two clasps together (fig.1.1).
2. Make sure the correct side is facing up (fig.1.2).
3. Fasten the two clasps together before inserting
them into the harness buckle. You should hear a
click (fig.1.3).
4. Pull the harness adjustment belt (6) so that the
part of the strap that covers the lap is not loose,
ensuring the harness is taut and the buckle closed.
open the harness buckle (4) by pressing the red
button (fig.1.4).
fig. 1
1 2
3 4
3.2. Harness buckle care
in order to ensure child safety it is essential that
the harness works correctly. if this is not the case
it is probably because of an accumulation of dirt or
foreign bodies.
incorrect operation is understood as:
• The buckle clasps are notably slow to release when
the red button is pressed.
• The buckle clasps cannot be inserted (they fall out
when they are inserted into the buckle).
39