Table of Contents
Advertisement
Installation Space
In order to ensure the daily maintenance and service of the unit, enough space shall be reserved between the units.
Unit without Shell:
Vibration Reduction:
It is recommended to install the shock absorber between the foundation and the unit supporting leg. If the rubber
damping pad is selected, its thickness shall be over 20 mm; If the damped-type spring shock absorber is selected, it
is necessary to make selection according to the unit's weight and the vibration source. It is recommended to install
the damped-type spring shock absorber between the foundation and the outdoor unit base (especially for place
whose unit adopts the rack stent installation and the roof installation). The vibration isolation device shall be selected
and installed correctly according to the design requirements, so as to meet the requirements of vibration isolation
and avoid the phenomena of solid-borne sound transmission and resonance. For the model and the construction of
the damped-type spring shock absorber, they shall be determined by the professionals. The proximal shock absorber
can be selected near the optimum load which is given in the following table.
Cooke Industries - Phone: +64 9 579 2185
11
Email: sales@cookeindustries.co.nz
Installation Requirements
Unit with Shell:
Web: www.cookeindustries.co.nz
Advertisement
Table of Contents
