4) Affix the supplied FAX Approval Label.
5) Connect the power plug to the outlet, and turn ON the main power switch.
6
Installation > Operation Setting
Installation
F-6-22
6
Installation > Operation Setting
Installation
Operation Setting
■ Type Setting
1) Set the TYPE of country/region to install this machine, and then press OK.
Service mode: FAX> TYPE> TYPE> Select the country/region> Press [OK]
2) Turn OFF and ON the main power switch to enable this setting.
■ Basic Setting
MEMO:
• When "System Manager Information Settings" is set, be sure to follow the direction of
user administrator in order to log in as an administrator.
• When installing the host machine at the same time and carring out the "installing
navigation" of host machine, the following procedures are unnecessary.
In this section, make only minimum settings required for FAX communication.
1) Set the user telephone number.
[Settings/Registration]> [Function Settings]> [Send]> [Fax Settings]> [Set Line]> [Line 2]>
[Register Unit Telephone Number]> Enter FAX number> [OK]
2) Set the type of telephone line.
[Settings/Registration]> [Function Settings]> [Send]> [Fax Settings]> [Set Line]> [Line 2]>
[Select Line Type]> Select the line type to connect> [OK]
3) Turn OFF/ON the main power switch after setting the user telephone numbers and the
type of telephone line.
■ Fax communication test
Perform communication test to check if the FAX function works properly.
1) Switch the screen to the Fax screen.
2) Send a test original from the equipment to a remote unit with which a communication test
can be performed and check if it can be sent correctly.
3) Send a test original from the remote unit for a communication test to the equipment and
check if it can be received correctly.
6-9
6-9