Mitsubishi Electric MJ-E130AL-H Instruction Manual page 21

3
1
Switch the power OFF.
2
Set the time you wish the unit to turn ON.
Blip
Press once, the POWER lamp lights,
operating mode indicator and " " on the
digital display flash, and "
Each press will change the display in
the sequence of 1 to 9 hours.
(Holding the switch will cause the display to
change continuously.)
. ...
Blip Blip
No display
(operation
stops)
3
Select operation mode.
Select the desired operation mode.
Set the DRYING INSIDE (auto) operation as
desired.
19
4
Change the louvre swing direction.
Select the desired louvre swing direction.
5
Confirm the time setting by
pressing the POWER switch.
Blip
The POWER lamp and timer display light.
The ON TIMER is set.
If both the timer display and operating mode indicator
blink, it means the POWER switch is not pressed.
(An alarm "blip blip" sounds for 1 minute.)
1 . 5
4 2
12
Press
" is displayed.
Blip
Blip
Blip
12–17
18
Press
The ON TIMER can be set between 1 to 9 hours.
Set the timer when the POWER is off.
Example of setting ON TIMER to 5 hours with
AUTO mode (setting: 60%), louvre swing setting
"Wide"
The remaining time will
decrease one hour after each
hour elapses.
When the set time is reached,
the unit automatically starts.
Cancellation
Press POWER switch
Blip
When the ON TIMER is set during the DRYING
INSIDE operation, the operation is stopped.
The ON TIMER function is not operable using a
commercially-available timer plug.
OFF
Press
The ON TIMER is
cancelled.
21