Table of Contents
Advertisement
OVERVIEW
•
Eight (8) programmable Light and Sound Modes.
•
Four (4) programmable Activation Delays.
Retains all programmed details in memory .
•
ON-READY-OFF Switch
•
Programming Switch (small, recessed) - use a small tool like a pen, pencil,
or handcuff key to activate
To Turn ON: Unit must be Readied by pressing ON-READY-OFF Switch,
which lights up Green. When ready to deploy , press Switch again, and the
Green light will start blinking, indicating that the programmed Activation Delay
has begun.
•
To Turn OFF: Pressing the same Switch once more. The Green light goes
off.
Note: Unit is shipped in mode 8 (safety lock). If no response, program unit as specified in
the next section.
PROGRAMMING
Light & Sound programmed by pressing recessed Programming Switch while
the ON-READY-OFF (O-R-O) Switch is in OFF mode. Audible sound provides
feedback. This programming must be entered within 4 seconds.
Press Once:
Press Twice:
Press 3 times:
Press 4 times:
Press 5 times:
Press 6 times:
Press 7 times:
Press 8 times:
Note: Modes are retained in memory .
Turbo Strobe and Sound: 2 sec., then STOP
Turbo Strobe and Sound: 10 sec. ON, 30 sec. OFF , then
Repeat
Light and Sound: 2 sec., then STOP
Light and Sound: 10 sec. ON, 30 sec. OFF , then Repeat
Turbo Strobe: 2 sec., then STOP
Light ON Continuous (must be turned off by user)
Sound: 2 sec., then STOP
Safety Lock
3
Advertisement
Table of Contents
