Advertisement
Document No. 129-565
Installation Instructions
April 28, 2015
6. Press the Configure tab and deselect Hide
Configured Devices.
7. In the list, select the EcoView 8 DO Module.
8. In the Device Configuration Wizard, press the
Decommission button.
9. Press the Accept button.
10. Return to the EcoView 8 DO Module and install it on
the correct EcoView Touchscreen network.
Resetting the EcoView 8 DO Module to
Manufacturer's Defaults
Use this procedure to reset the EcoView 8 DO
Module to the manufacturer's defaults.
➤
Press and hold the recessed RESET button for
more than 10 seconds and then release it.
The LEDs on the EcoView 8 DO Module should
cycle off, then turn on again.
FCC and IC Interference
Requirements
"This device complies with Part 15 of the FCC Rules
and with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two
conditions (1) this device may not cause harmful
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device."
Page 4 of 5
« Ce dispositif est conforme à la partie 15 des règles
de FCC et aux normes permis-exemptes du Canada
RSS d'industrie. L'opération est sujette aux deux
conditions suivantes (1) que ce dispositif peut ne pas
causer l'interférence nocive, et (2) ce dispositif doit
accepter n'importe quelle interférence, y compris
l'interférence qui peut causer le fonctionnement peu
désiré du dispositif. »
Per RSS-Gen Issue 3 (December 2010 Section 7.1.3)
FCC Note
This device complies with Part 15 of the FCC rules.
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
FCC and IC Radiation Exposure
Statement for Mobile Devices
"This equipment complies with FCC and IC radiation
exposure limits set forth for an uncontrolled
environment. This equipment shall be installed and
operated with minimum distance 20cm between the
radiator and your body. This transmitter must not be
re-located or operating in conjunction with any other
antenna or transmitter."
(For compliance with FCC Code of Federal
Regulations Title 47 Part 2.1093)
Siemens Industry, Inc.
Advertisement
