Table of Contents
Advertisement
Caution
The Easy Fit System must be assembled prior to use . Should you have any questions
during assembly contact your local authorized dealer .
•
Under no circumstance should the track, lift and sling(s) or entire system be put in control of a person
who has not been properly trained in the use and care of this equipment . Failure to adhere to this warning
may result in serious injury to the operator, and/or the individual being lifted/transferred .
Never install the Bottom foot plate on the top portion of post section or vice versa . See section 'Assembly'
•
instructions .
Easy Fit System and associated lift and sling(s) are not toys . Do not use them for unsafe practices . Do
•
The
not allow children to play with this equipment or any of its components .
•
The manufacturer's warranty is void if persons unauthorized to perform work undertake this on the
Fit System .
•
Ensure rubber feet are cleaned and dry prior to each use . See section "Cleaning Rubber Base Instructions."
•
Ensure that the pressure gauge is in the safe zone during set up .
•
Check the posts during installation are level both visually and with master spirit level .
•
In places where more than one operator will be responsible for using the
and sling(s), it is imperative that all operators be trained in its proper use .
•
Never expose the Easy Fit directly to water . Warranty does not cover any misuse or abuse of the Easy Fit
system .
•
To maintain optimum function, the
the section titled "Pre-Use Inspection and Maintenance".
•
Any accessories used with the
that they are in good working order . Check for signs of wear or fraying prior to use . Report any unusual
wear or damage immediately to your local authorized dealer .
Easy Fit System and associated lift, and sling(s) are intended only for lifting and transferring of
•
The
a person . The manufacturer will not be responsible for any damage caused by the misuse, neglect or
purposeful destruction of the lift and/or its associated components .
•
Do not in any circumstance exceed the maximum load for this piece of equipment . Refer to the
"Specifications of the
•
The installation of the
exceed the maximum rated load of any of the components .
•
Ensure that a clear space is maintained around the
obstacles out of the way before performing a transfer .
Easy Fit System has been designed to lift vertically at its maximum load and at maximum height . Do
•
The
not attempt to lift an individual at an angle to the track .
Easy Fit should be inspected and maintained on a regular basis . See
Easy Fit System including lift and sling(s), should be checked to ensure
Easy Fit System" section of this manual .
Easy Fit System, lift, accessories, and sling are certified to a maximum load . Do not
Easy Fit System, associated lift
Easy Fit System . Remove all furniture and other
Easy
5
Advertisement
Table of Contents
