Table of Contents
Advertisement
Assembly (continued).....
9 . Check to ensure that the blue marker on
Pressure Guage (located at the top of the
Support Post) is confortably into the green
'safe' zone on both sides . If it is not, it will
be necessary to release the Lever again and
apply more than two clicks before closing it .
11 . Repeat the procedure to built the second
Support Post and set it perpendicular to the
first .
10 . Push the Safety Lock back into place until
it clicks and rotate the post to ensure that the
lever is facing 90 degrees to the position of
the second post .
12 . Lift the Track (N .B . You may need
assistance from another person and steps to
reach) and hook one end on to the Support
Post Pins .
11
Advertisement
Table of Contents
