Advertisement
Trash Bag Kit
GrandStand
Model No. 121-7530
Install this kit on the left side of the machine. Installing
it on the left side allows for installation of the Chute
Gate Kit on the right side.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1
Installing the Bag Bracket to
the Mower
Parts needed for this procedure:
1
Bag bracket
2
Bolt, 3/8 x 1 inch (thread forming)
Procedure
Installing this kit on the left side allows for installation
of the Chute Gate Kit on the right side.
Install the bracket to the side of the machine with 2 bolts
(3/8 x 1 inch) (Figure 1). The bolts are thread forming
bolts. The holes do not require tapping.
© 2012—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Mower
Description
Bag bracket
Bolt, 3/8 x 1 inch (thread forming)
Cup holder
Screw, #10 x 5/8 inch
Flat washer
Lock nut, #10
Trash bag
Register at www.Toro.com.
Qty.
1
Install the bag bracket to the mower
2
1
2
Install the cup holder
2
2
1
Install the trash bag
g020053
Figure 1
1. Left side of machine
2. Bracket
Form No. 3374-108 Rev A
Installation Instructions
Use
1
2
3. Bolt, (3/8 x 1 inch)
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
3
Advertisement
Table of Contents
Related Manuals for Toro 121-7530
Summary of Contents for Toro 121-7530
- Page 1 Form No. 3374-108 Rev A Trash Bag Kit GrandStand ® Mower Model No. 121-7530 Installation Instructions Install this kit on the left side of the machine. Installing it on the left side allows for installation of the Chute Gate Kit on the right side.
- Page 2 Installing the Cup Holder Installing the Trash Bag Parts needed for this procedure: Parts needed for this procedure: Cup holder Trash bag Screw, #10 x 5/8 inch Procedure Flat washer Lock nut, #10 Install the trash bag into the slots in the bag bracket (Figure 3).
Need help?
Do you have a question about the 121-7530 and is the answer not in the manual?
Questions and answers