Table of Contents
Advertisement
Installation -
Installation
2
4
Mounting Template
1
3
5
Using the mounting template sheet or the
1
camera itself, mark and drill the necessary holes
in the wall or ceiling.
Connect the network cable and power cable
2
respectively. See 'Installation - Cabling' for
details.
To use the camera's waterproof wiring:
a. Install the LAN cable into (a) .
b. (b) will be assembled to (a) with a 1/4 turn.
c. Thread (c) tightly to (b).
a
NOTE: To ensure moisture seal, make sure the
o-ring is in place between (a) and (b). In extreme
environments use of an outdoor rated sealer is
recommended.
NOTE: When using the waterproof cap, crimp the
RJ45 connector after passing the cable through
the waterproof cap.
Use the two mounting screws to mount the
3
camera on the mounting surface.
Loosen the pan/tilt/rotate screws a little
before fixing the camera.
Adjusting the camera's angle and view and
4
tighten the pan/tilt/rotate screws to lock the
camera's position.
Remove the protective film from the camera's
5
lens to complete the installation.
8
c
b
Advertisement
Table of Contents
