Troubleshooting - Scandomestic SFS 242 W User Manual

Troubleshooting

Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician
or competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance dose
not work
Appliance
freezes too much
The food is not
frozen enough.
Heavy build-up
of frost on the
door seal.
Unusual noises
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here,
refer to the rating plate.
Possible cause
Mains plug is not plugged in or is
loose, or product is turn off
Fuse has blown or is defective
Socket is defective
Temperature is set too cold or the
appliance runs at -22' C setting.
Temperature is not properly adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the last
24 hours.
The appliance is near a heat source.
Door seal is not air-tight.
Appliance is not level.
The appliance is touching the wall or
other objects.
A component, e.g. a pipe, on the rear
of the appliance is touching another
part of the appliance or the wall.
Solution
Insert mains plug and turn on the
appliance
Check fuse, replace if necessary.
Mains malfunctions are to be correct-
ed by an electrician.
Turn the temperature regulator to a
warmer setting temporarily.
Please look in the initial Temperature
Setting section.
Open the door only as long as neces-
sary.
Turn the temperature regulation to a
colder setting temporarily.
Please look in the installation location
section.
Carefully warm the leaking sections of
the door seal with a hair dryer (on a
cool setting). At the same time shape
the warmed door seal by hand such
that it sits correctly.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the com-
ponent out of the way.