Scandomestic SFS 242 W User Manual page 32

Levelling the unit
To do this adjust the two levelling feet at
front of the unit.
If the unit is not level, the doors and mag-
netic seal alignments will not be covered
properly.
Placement
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
For refrigerating appliances with climate
class:
- extended temperate: 'this refrigerating
appliance is intended to be used at
ambient temperatures ranging from
10°C to 32°C (SN);
- temperate: 'this refrigerating appliance
is intended to be used at ambient tem-
peratures ranging from 16°C to 32°C
(N);
- subtropical: 'this refrigerating appliance
is intended to be used at ambient tem-
peratures ranging from 16°C to 38°C
(ST);
- tropical: 'this refrigerating appliance is
intended to be used at ambient tem-
peratures ranging from 16°C to 43°C
(T);
Location
The appliance should be installed well away
from sources of heat such as radiators,
boilers, direct sunlight etc. Ensure that air
can circulate freely around the back of the
cabinet. To ensure best performance, if the
appliance is positioned below an overhang-
ing wall unit, the minimum distance be-
tween the top of the cabinet and the wall
unit must be at least 100 mm. Ideally,
however, the appliance should not be
positioned below overhanging wall units.
Accurate leveling is ensured by one or
more adjustable feet at the base of the
cabinet.
This refrigerating appliance is not intended
to be used as a built-in appliance.
Warning! It must be possible to disconnect
the appliance from the mains power sup-
ply; the plug must therefore be easily ac-
cessible after installation.
This refrigerating appliance is not intended
to be used as a built-in appliance;
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power
supply socket is not earthed, connect the
appliance to a separate earth in compliance
with current regulations, consulting a quali-
fied electrician.
The manufacturer declines all responsibility
if the above safety precautions are not
observed.
This appliance complies with the E.E.C.
Directives.