Troubleshooting - Scandomestic SKS 56 B User Manual

FIGURATION OF THE REFRIGERATOR
(1) lce-tray
(2) Thermostat
(3) Evaporator
(4) Shelf
(5) Drip tray
(6) Bottle rack
SETTINGUP
• The appliance can be placed wit h its rear panel directly
against the wall. For a good air circulation, the vent grille at
the back of the worktop must not be blocked , It shou ld be
placed on fiat and finn ground lest it gives off higher noise
than usuaJ.
• Poorly ventilated rooms are unsuitable. Avoid positioning
the appliance in direct sunshine or expose d to similar
sources of heat.
• The appliance sha ll not be use d in open air and shall not be
exposed to rain.
THERMOSTAT
• The knob graduation 0, l , 2, 3, 4, 5, 6, 7,
does not stand for concrete temperature.The smaller the
numbers ,the higher the temperature in the compartment
and vice versa.Usually,it 's better to put the thermostat in
Pos. " l ",Pos. "4".Pos. "O" shows the power is cut off.
STORING FOOD
• The temperatures in different positions inside the
refrigerator are different due to different refrigeratio n
distribution.Thus when store food, select proper position
to meet your needs.
• The warmest setting is "1", Temperature from high too low
in order as "2", "3", "4".
ICE-MAKING
To make ice cubes, fill 4/5 of the ice cube tray with water, and
place the tray on the bottom of the freezer. Turn the ice
cube tray or place it briefly in hot water under the tray.
Note: Do not use a knife or e.g., when the ice cube tray is
removed from the freezer.
NOTES ON STORAGE
• Where necessary, food should be packed in bags, avoiding
giving off strong odours or getting wet or dry.
• Do not store food too full in the appliance. Allow space
among the packages of food for a perfect refrigerating.
• Hot food or liquid must be allowed to cool to room
temperature before placing it in.
CLEANING
• The appliance can only be cleaned at drawn network plug.
Clean it with lukewarm water containing a little detergent. In
any case do not use hot water,corrosive scouring agent and
anything rough.
NOTE: Do not use anything rough for cleaning.
DEFROSTING
When defrosting, switch off the appliance. Remove food from
the ice chamber, then it will be defrosted automatically. When
defrosting process has been completed; the drip-tray should be
depleted. Replace the food and switch on the appliance.
NOTES
• If the appliance remains out of use for some time, pull out
the plug to disconnect the appliance from power supply.
Clean the interior as described above to prevent odours
from forming inside.
• The appliance door should be opened as little and briefly as
possible to reduce energy consumption.
• In the event of power failure, try to keep the appliance
closed to maintain the refrigera tion as long as possible.

TROUBLESHOOTING

In the event of a fault occurring during operation, check first if
the fault is due to an operation error. You can repair the follow-
ing fault s yourself.
1. The appliance does not run.
2. It is not switched on properly, or mains plug properly
inserted in the socket.
3. The thermostat knob is turned to position "O" .
4. Supply voltage is too low.
The temperature inside the appliance is not low enough.
1. The appliance is too full of food.
2. The appliance is located too near a source of heat.
3. The door is not properly closed or is opened too frequently.
4. The vent grille is covered over.
Excessive noise from the appliance.
1. The appliance is not standing securely on the ground.
If none of these circumstances applies and you are not able to
repair the fault, please Contact the service point.