Lubrication Schedule; Lubrication Procedure - MCi 102D Series Maintenance Manual

102D SERIES MAINTENANCE MANUAL

LUBRICATION SCHEDULE

King pins, tie rod assemblies, and ball studs
Lubricate king pins, bushings, and the ends of cross
tube assemblies every 50,000 miles (80,000 km) or every
twelve months, whichever occurs first.
NOTE: Inspect the ball stud boot seal every 96,000
miles (154,000 km. If the seal is damaged, replace the
complete tie rod end.
NOTE: On all axles that uses a Anti Tilt" seal style seal
on the drop end assemblies should be serviced every
10,000 miles (16,000 km).
Wheel bearings
Lubricate wheel bearings according to the following
schedule:
Grease lubrication
When the hub seals are replaced;
When the brake pads are replaced of relined;
Every 30,000 miles (48,000 km). If the mileage each
year is less than 30,000 miles, lubricate the wheel
bearings twice a year.
Oil lubrication
Check oil every 1000 miles.
Change oil when seals are replaced or brakes are
relined.
Change oil every 100,000 miles or once a year.
01-FRONT AXLE

LUBRICATION PROCEDURE

King pins
raise the vehicle.
the top and bottom of the knuckle (Figure 45).
thrust bearing seal and the upper shim pack.
Cross tube
Lubricate the cross tubes according to the following
procedure:
lubricant through the grease fittings (Figure 46).
1. Make sure the tires touch the ground. DO NOT
2. Clean off all grease fittings before lubrication.
3. Lubricate the pins through the grease fittings on
FIGURE 45. King pin lubrication
4. Apply lubricant until new lubricant comes from the
1. Make sure the tires touch the ground.
2. Use a grease gun to lubricate the assembly. Apply
August 2000
Date
1B 21
Page